There’s a big bin of 5 digit, 7-segment displays sitting in our electronics lab. It’s the sort of thing that cries out for a project. I found one that’s the perfect shape for a digital speed readout for our big drill press, whose mechanical RPM indicator was broken.
Clik here to view.
Testing out the display PCB. It’s got 3 16 bit shift registers.
The display was pretty simple to reverse-engineer. There’s a header on the back that’s connected directly to the relevant pins on the first shift register. Apply power, fire up a basic sketch built around shiftOut(), and away we go.
Clik here to view.
My test rig, showing that the RPMs pretty close.
My code (patches welcome!) is not terribly complex. Basically I use a Hall effect sensor to trigger an interrupt every time a magnet glued to a wheel in the drill press passes. The time between interrupts is used to calculate RPM.
Clik here to view.
Magnet + Hall effect sensor.
All told, I spent maybe four or five hours on this project. It’s probably the simplest possible solution to the problem, and my total investment is less than $10 in parts. And we’ve got an accurate readout of the speed of this big drill press.
Clik here to view.
Complete system.
I’m out
-loans
